In five minutes, I cut down a 1x4 board to make this great organization piece for my daughter's bathroom drawer.
I measured the width of the drawer and cut 2 pieces to length. Then I measured the length of the drawer and divided by 3 to estimate the section pieces, cutting four pieces. Always estimate a bit long, so you can cut down to slide into place.
I assembled two "T" shaped sections with a width cut and a divided length cut (see below). I used the kreg screws, but nails will work just as well.
|Here are the two "T" pieces assembled and the other two divider pieces.|
These fit perfectly in place.
|I left the two front pieces unattached so she can adjust if she needs to change it.|
Now I want to add this to all the drawers.
Thank you for checking out this simple project. Be sure to check out the other projects here.